How to Use the Dome Gen 2 Stand Fasteners Kit

Quick answer

Use the Dome Gen 2 Stand Fasteners Kit to securely assemble or repair your oven stand. Follow the steps below to avoid loose connections and ensure a stable setup.

Step-by-step installation guide

1. Step 1: Gather tools and parts: Unpack the fasteners kit and confirm you have all bolts, washers, and nuts. You will also need a suitable wrench or socket set. Lay out the stand components on a clean, flat surface. Check the kit contents against the manual before starting.
2. Step 2: Align the stand frame sections: Position the frame sections as shown in the product manual. Insert bolts through the aligned holes, then add a washer and thread on the nut finger-tight. Do not fully tighten yet. Common mistake: over-tightening before all bolts are in place can misalign the frame.
3. Step 3: Tighten all fasteners evenly: Once all bolts are started, use your wrench to tighten each one evenly in a crisscross pattern. This distributes stress and prevents the frame from twisting. Torque to a snug fit—do not strip the threads. If a bolt won't turn smoothly, stop and check for cross-threading; do not force it.
4. Step 4: Final stability check: Place the assembled stand on level ground. Gently rock the stand to confirm it is rigid. Recheck all fasteners after the first use, as settling can cause slight loosening. Re-tighten after the first cook session to maintain stability.

Product facts

• Dome Gen 2 Series Stand Fasteners Kit: This is a full set of fastenings used for Dome Gen 2 stand assembly. It is included with the original product as standard. You don't need to buy this kit unless your original hardware is lost or damaged, saving you an unnecessary purchase.